hjelp: Problemer med auto høydejustering på A4 b6 etter senking!

Jeg har en A4 b6 02mod med orginal xenon lys i nærlys.

 

Ca 2uker etter at jeg senket bilen min så fikk jeg feilmelding på høyre høydejusterings motor. Jeg byttet denne, men feilen var der fortsatt! Jeg har hørt noe om at det er et vanlig problem dette når man senker disse bilene, men jeg har ikke funnet noen løsning på det.

 

Så da lurer jeg på om det er noen kloke hoder her som kan fortelle meg hva jeg skal gjøre!

Kan det stemme at jeg må kalibrere høydejusteringa eller noe sånt?

For det første må du grunn instille lysene igjen.(Vag com)

Om du får feil meld etterpå,kan stage til følerne bli for lange,slik at du må korte de inn noe.

Jeg har hatt samme problemet på min, dro på verksted og fikk det fikset iogmed at lysene må settes i rett høyde og vinkel.

Men her har du en "how to" hvis du vil grunninnstille lysene selv.

 

Xenon Headlamp Adjustment

 

This procedure applies only to older Xenon systems that use KW-1281. Procedures for specific vehicles, including newer cars that use KWP-2000 or CAN systems can be found in the Ross-Tech wiki.

 

This procedure details how to perform a Xenon Headlamp Adjustment on many VW/Audi vehicles equipped with Xenons (HID's). This procedure cycles the motorized headlamp adjusters to their center position so that the beams can be adjusted. This does NOT align the headlamps by itself.

You still need to manually adjust the headlamps via the adjusting screws as referenced against a suitable aiming target.

 

If this procedure is only partially performed, there may be a DTC stored in the Xenon Range memory indicating "Headlights not adjusted". To clear this, you need to complete the entire procedure.

 

There are certain test conditions that must be met before doing this procedure:

 

Vehicle must be parked on level ground and "settled" on its suspension

 

Parking brake should be OFF

 

Ignition should be in the "On" position

 

Headlamps should be "Off"

 

 

--------------------------------------------------------------------------------

 

Procedure for Aligning Xenon Headlamps:

 

[select]

[55 - Xenon Range] (For some newer vehicles, use [29 - Left Light] instead )

[basic Settings - 04]

Group 001

[Go!]

 

Wait at least 20 seconds for the headlamp motors to move. The headlamps are now in their adjustment position. Turn on headlights. Adjust them via their manual adjusting screws as referenced against a suitable aiming target.

 

Scroll up to Group 002. The Xenon Range controller has now learned this position as its Home position.

 

Click the [Done, Go Back] button and you're all set.