#1 Skrevet Januar 8, 2006 hvordan for man brukt disse i vag com? ; VAG-COM Measuring Block Labels for ; All OBD-I VR6, ECU p/n 021-906-258-xx ; ; 1,0,General Engine Data 1,1,RPM,Engine Speed 1,2,Coolant,Temperature 1,3,O2,Active 1,4,Ignition,Timing ; 2,0,General Engine Data 2,1,RPM,Eng Speed 2,2,Injector,ON Time 2,3,Battery,Voltage 2,4,EGR Temp,(if available) ; 3,0,General Engine Data 3,1,RPM,Engine Speed 3,2,Engine,Load (%) 3,3,Throttle Angle, 3,4,Intake Air,Temp - Manifold ; 4,0,General Engine Data 4,1,RPM,Engine Speed 4,2,Engine,Load (%) 4,3,Vehicle,Speed 4,4,Switch Postn,Binary Codes ; ; Binary Codes - Grp 04, Measuring Channel 4. ; 10000 - Acceleration enrichment ; 01000 - Wide Open Throttle ; 00100 - Partially Open Throttle ; 00010 - Idle Position ; 00001 - Deceleration ; 00000 - Switch position NOT OK ; (activate DTC memory again if this code appears) ; 5,0,Idle Control 5,1,RPM,Engine Speed 5,2,ISV,Adaptation 5,3,ISV,Duty Cycle(%) 5,4,Switch Postn,Binary Codes ; ; Binary Codes - Grp 05, Measuring Channel 4. ; 10-00 - A/C Compressor ON ; 01-00 - A/C Compressor OFF ; 00-10 - Transmission engagement (for automatic transmission ONLY) ; 00-01 - Drive Step (for automatic transmission ONLY) ; 6,0,Fuel Trim (O2 Sensor) 6,1,O2,Active 6,2,Idle,Adapted Value 6,3,Part Throttle,Adapted Value 6,4,Full Throttle,Adapted Value ; ; Less than 1.0 is rich, greater than 1.0 is lean ; 0 Del dette innlegget Lenke til innlegg Del på andre sider Flere delingsalternativer...
#2 Skrevet Januar 12, 2006 ingen som har peiling på odb1 og vag-com? 0 Del dette innlegget Lenke til innlegg Del på andre sider Flere delingsalternativer...